Bosch VG5-7230-CPT5, Руководство по эксплуатации

Страница: 47 / 152

AUTODOME IP starlight 7000 HD Installing the Roof Parapet and Pipe Mounts | en 47
Bosch Security Systems Operation Manual 2016-07 | 1.0 | F.01U.283.679
10. Thread the Dome Cap onto the down pipe and tighten securely. See the illustration
below.
!
Warning!
You must thread the Dome Cap onto the Down Pipe until it is tight. Failure to do so can result
in damage, serious injury, or death.
Figure 8.23: Attach Dome Cap
1 Thread Sealant or tape
2 Dome Cap
11. Run a bead of RTV Silicon sealant around the down pipe/Dome Cap interface to seal any
gaps between the down pipe and the Dome Cap.
12. Proceed to Wire the Pipe Interface Board, page 49 .
Notice!
Use a guy-wire to aid in stabilizing the Parapet Arm. Replace the 1/4 inch cap screw with a
threaded 1/4-inch stainless steel eye bolt (not supplied). Loop the guy-wire through the eye
bolt and attach both ends to anchor spots on the roof.
8.5 Installing the VG4-A-9543 Pipe Mount
This section details the installation steps for the VG4-A-9543 Pipe Mount. If you are installing
the Roof Parapet mount, refer to
Installing the VGA-ROOF-MOUNT, page 45 for instructions.
Notice!
Customer must supply 1-1/2 inch (NPS) pipe threaded on both ends with a minimum length
of 5 inches (12.7 cm).
You must use Teflon tape for thread-sealing compound.
All screws shall be tightened securely.