AUTODOME IP starlight 7000 HD
Installing the Optional SD Card | en
21
Bosch Security Systems
Operation Manual
2016-07 | 1.0 | F.01U.283.679
5
Installing the Optional SD Card
The camera can accept a customer-supplied SDHC or SDXC memory card (hereafter referred
to as “SD card”) for local storage. (The camera will not accept MicroSD cards.) Using an SD
card is optional.
Ideally, you should install the SD card before mounting the camera. To install the SD card,
follow these steps:
!
Caution!
Risk of electrostatic discharge!
Use proper CMOS/MOS-FET handling precautions and observe proper ESD safety precautions
(such as wearing grounded wrist straps) to avoid electrostatic discharge.
!
Warning!
Bosch recommends disconnecting power to the camera while adding or removing an SD card.
1.
Follow the steps in one of these sections (depending on the type of camera mount):
Remove the bubble from an in-ceiling housing, page 65
or
Remove the bubble from a
pendant housing, page 65
.
2.
Locate the SD card slot (item one in the figure below).
Figure 5.1: Camera cross section with SD card slot
3.
Orient the card so that the side with the golden contacts faces away from the dome and
towards the housing. The contacts should be at the top as you hold the SD card.
4.
Slide the SD card into the slot. Press down the end of the SD cards until you hear a click
and the card locks into place.
5.
Follow the steps in one of these sections (depending on the type of camera mount):
Replace the bubble in an in-ceiling housing, page 66
or
Replace the bubble in a pendant
housing, page 67
.
Содержание VG5-7230-CPT5
Страница 1: ...AUTODOME IP starlight 7000 HD VG5 7230 CPT5 VG5 7230 EPC5 VG5 7230 EPR5 en Operation Manual ...
Страница 2: ......
Страница 151: ......