Bosch VG5-7230-CPT5, Руководство по эксплуатации

Страница: 26 / 152

26 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts AUTODOME IP starlight 7000 HD
2016-07 | 1.0 | F.01U.283.679 Operation Manual Bosch Security Systems
Power Supply Box Connections
The following figure is a detailed illustration of the Pendant Arm Power Supply Box, which
includes the fuse specifications.
TRANSFORMER
(115/230VAC
MODELS)
P101
1 2 3
6 5 4 3 2 1 6 5 4 3 2 1
P106
XF102
XF103
XF101
J103 J103 J103 J103
J102 J102 J102 J102
J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101J101 J101 J101 J101 J101 J101 J101 J101 J101 J101J101 J101 J101 J101 J101 J101J101 J101 J101 J101J101 J101
(LED)
P1
0
7
5
4
3
2 1
GND TXD RXD C+ C-
P105
GND TXD RXD C+ C-
HTR DOME
a
(FUSE)
(FUS
E)
(FUS
E)
(FUS
E)
(FUSE)
(FUS
E)
(FUS
E)
(FUS
E)
(FUS
E)
(FUSE) (FUSE)
(FUSE) (FUSE) (FUSE) (FUSE) (FUSE)(FUSE) (FUSE) (FUSE) (FUSE)
LINE NC NEUT
Figure 7.4: Pendant arm power supply box
1 Ground Screw 7 P101 Connector; Power In (120 VAC / 220
VAC)
2 From Harness (Nexus cable bundle) 8 P106 Connector; Control In/Out for external
audio input and output
3 In/Out; 1/2 in. (15 mm) NPS Fitting 9 P105 Connector; Audio to camera
4 Ethernet connector 10 Power In; 3/4 in. (20 mm) NPS Fitting
5 P107 Connector; 24 VAC to camera 11 Audio Input/Output; 3/4 in. (20 mm) NPS
Fitting (labeled “SERIAL COMMUNICATIONS”)
6 In/Out; 1/2 in. (15 mm) NPS Fitting
!
Warning!
In earlier Bosch AUTODOME cameras, cable 8 in the ARM mount is labeled “Control In/Out”
and was used for external RxD/TxD and Biphase communications. In the AUTODOME 7000
Series cameras: If you are mounting an AUTODOME 7000 Series camera to an ARM mount
that was wired for an earlier model of Bosch AUTODOME, you must either re-wire cable 8 to
be audio input and output, or disconnected it from the power supply.
Cables/wires that are routed through number 2 in the illustration above come from the Nexus
cable bundle that is in the pendant Arm.