Bosch NEI-308V05-13WE, Руководство пользователя

Страница: 37 / 124

Dinion IP Infrared Imager Operation via the Browser | en 37
Bosch Security Systems, Inc. User Manual F.01U.263.416 | 3.1 | 2012.09
7.2 Configuring the NEI-30 Camera
To operate the camera in your network, you must assign a valid
network IP address to the camera. The default IP address is
192.168.0.1, but you may need to change this address if it
conflicts with another device on your network. Refer to
Section 8.3 Basic Mode: Network, page 45 for more information.
To configure the camera for your network, you need the
following information:
– Unit IP address: An identifier for the camera on a TCP/IP
network. For example, 140.10.2.110 is a valid syntax for an
IP address.
– Subnet mask: A mask used to determine the subnet to
which an IP address belongs.
– Gateway IP address: A node on a network that serves as an
entrance to another network.
– Port: An endpoint to a logical connection in TCP/IP and
UDP networks. The port number identifies the use of the
port for use through a firewall connection.
The NEI-30 defaults are as follows:
– IP Address: 192.168.0.1
– Subnet Mask: 255.255.255.0
– Gateway IP Address: 0.0.0.0
The following sections provide instructions about installing the
software necessary to view images over an IP connection,
configuring the IP network settings, and accessing the NEI-30
images from a Web browser.
NOTICE!
Ensure that the graphics card is set to 16-bit or 32-bit color. If
you need further assistance, contact your PC system
administrator.
NOTICE!
Ensure that the network parameters of your cameras are
available before you begin configuration.