Bosch NEI-308V05-13WE, Руководство пользователя

Страница: 91 / 124

Dinion IP Infrared Imager Configuration via IP, Advanced Mode | en 91
Bosch Security Systems, Inc. User Manual F.01U.263.416 | 3.1 | 2012.09
2. Click the Set and Reboot button. The camera is rebooted
and the changed settings are activated.
SNMP
The camera supports the SNMP V2 (Simple Network
Management Protocol) for managing and monitoring network
components, and can send SNMP messages (traps) to IP
addresses. The unit supports SNMP MIB II in the unified code. If
you want to send SNMP traps, enter the IP addresses of one or
two required target devices here.
If you select On for the SNMP parameter and do not enter an
SNMP host address, the camera does not send SNMP traps
automatically, but only replies to SNMP requests. If you enter
one or two SNMP host addresses, SNMP traps are sent
automatically. Select Off to deactivate the SNMP function.
1. SNMP host address / 2. SNMP host address
If you want to send SNMP traps automatically, enter the IP
addresses of one or two required target units.
SNMP traps
You can select which traps are to be sent.
1. Click Select . A list opens.
2. Click the checkboxes to select the required traps. All the
checked traps will be sent.
3. Click Set to accept the selection.
Authentication
If a RADIUS server is employed in the network for managing
access rights, authentication must be activated here to allow
communication with the unit. The RADIUS server must also
contain the corresponding data.
To configure the unit, you must connect the camera directly to a
computer using a network cable. This is because
communication via the network is not enabled until the Identity
and Password parameters have been set and successfully
authenticated.
Identity
Enter the name that the RADIUS server is to use for identifying
the camera.