Bosch DSA E Series, Руководство по установке

Страница: 83 / 150

E2600 DSA E-Series iSCSI Disk Arrays Turning on the Power and Checking for Problems | en 83
Bosch Security Systems Installation Manual - | V2 | 2012.09
AA The ESM A firmware is in the process of booting (the diagnostic
indicator is not yet set).
bb The ESM B firmware is in the process of booting (the diagnostic
indicator is not yet set).
L0 The controller types are mismatched, which result in a suspended
controller state.
L2 A persistent memory error has occurred, which results in a
suspended controller state.
L3 A persistent hardware error has occurred, which results in a
suspended controller state.
L4 A persistent data protection error has occurred, which results in a
suspended controller state.
L5 An auto-code synchronization (ACS) failure has been detected,
which results in a suspended controller state.
L6 An unsupported host interface card has been detected, which
results in a suspended controller state.
L7 A sub-model identifier either has not been set or has been
mismatched, which results in a suspended controller state.
L8 A memory configuration error has occurred, which results in a
suspended controller state.
L9 A link speed mismatch condition has been detected in either the
ESM or the power supply, which results in a suspended controller
state.
Lb A host interface card configuration error has been detected, which
results in a suspended controller state.
LC A persistent cache backup configuration error has been detected,
which results in a suspended controller state.
Ld A mixed cache memory DIMMs condition has been detected, which
results in a suspended controller state.
LE Uncertified cache memory DIMM sizes have been detected, which
result in a suspended controller state.
LF The controller has locked down in a suspended state with limited
symbol support.
LH A controller firmware mismatch been detected, which results in a
suspended controller state.
LL The controller cannot access either midplane SBB EEP-ROM, which
results in a suspended controller state.
Ln A canister is not valid for a controller, which results in a suspended
controller state.
LP Drive port mapping tables are not detected, which results in a
suspended controller state.
LU The start-of-day (SOD) reboot limit has been exceeded, which
results in a suspended controller state.
Table 11.15 Supported Diagnostic Lock-Down Codes on the Seven-Segment Display
Diagnostic Code Description