Bosch DSA E Series, Руководство по установке

Страница: 141 / 150

E2600 DSA E-Series iSCSI Disk Arrays Upgrading Memory in the E2600 Controller Canisters | en 141
Bosch Security Systems Installation Manual - | V2 | 2012.09
8. Disconnect the following cables from both controller canisters.
– Host interface cables
– Drive interface cables
– Ethernet cables
If fiber-optic cables are present, you can lift the two release levers and partially remove
the controller canister. Opening these release levers makes it easier to press down on
the fiber-optic cable release tab.
9. Remove both controller canisters from the controller-drive tray (see Figure 19.3 ).
– Unlock and pull out the release levers to release the controller canisters.
– Using the release levers and your hands, pull both controller canisters out of the
controller-drive tray.
– Set each controller canister on a flat, static-free surface near the controller-drive
tray. Position the controller canister so that you can access the top cover.
Figure 19.3 Removing a Controller Canister
10. On each controller canister, press down on both of the top cover latch buttons, and slide
the top covers to the rear (see Figure 19.4 ).
NOTICE!
Figure 19.3 shows controller A being removed. You remove controller B in the same way,
1 Release Levers
2 Controller Canister