Bosch DSA E Series, Руководство по установке

Страница: 106 / 150

106 en | Replacing a Power-Fan Canister in the Controller-Drive Tray E2600 DSA E-Series iSCSI Disk Arrays
- | V2 | 2012.09 Installation Manual Bosch Security Systems
Figure 15.3 Removing a Power-Fan Canister
11. Make sure that the Power switch on the replacement power-fan canister is turned off,
and plug in the power cord.
12. Slide the replacement power-fan canister all the way into the controller-drive tray. Rotate
the latches towards the center to lock the power-fan canister into place.
13. Attach the plastic strain relief to the power cord, and make sure that it fits snugly up
against the power-fan canister.
14. Turn on the Power switch on the new power-fan canister.
15. Check the Power-Fan Output DC Power LED, the Power-Fan Input AC Power LED, and
the Power-Fan Service Action Required LED on the new power-fan canister (see step 6).
16. Based on the LED status, perform one of these actions:
– The Power-Fan Output DC Power LED and the Power-Fan Input AC Power LED are
on and the Power-Fan Service Action Required LED is off
Go to step 18.
– The Power-Fan Output DC Power LED and the Power-Fan Input AC Power LED are
off or the Power-Fan Service Action Required LED is on
Check that the power-fan canister is installed correctly. Reinstall the power-fan can-
ister. Go to step 17.
17. Did this action correct the problem?
– Yes
Go to step 18.
– No
If the problem is not resolved, contact your Customer and Technical Support repre-
sentative.
18. Complete any remaining Recovery Guru procedures, if needed.
19. Using the LEDs and the storage management software, check the status of all of the trays
in the storage array.
98020-03