BMW X2 2022, Руководство пользователя

Страница: 200 / 308

Synchronizing the universal remote control
with the system:
1. Park the vehicle within range of the remote-
controlled system.
2. Program the desired button on the interior
mirror as described.
3. Locate and press the synchronizing button
on the system being programmed, e.g. at
the garage gate. You have approx. 30 sec-
onds for the next step.
4. Hold down the programmed button on the
interior mirror for approximately 3 seconds
and then release it. If necessary, repeat this
step up to three times in order to end syn-
chronization. Once synchronization is com-
plete, the programmed function will be car-
ried out.
Reprogramming individual buttons
1. Turn on the ignition.
2. Press and hold the interior mirror button to
be programmed.
3. As soon as the LED on the interior mirror
flashes orange after approx. 20 seconds,
release the button.
4. Hold the hand-held transmitter for the sys-
tem to be used approx. 1 to 12 in/2.5 to
30 cm away from the buttons on the inte-
rior mirror. The required distance depends
on the hand-held transmitter.
5. Press and hold the button of the desired
function on the hand-held transmitter.
Canada: if programming with the hand-held
transmitter was interrupted, hold down the
interior mirror button and repeatedly press
and release the hand-held transmitter but-
ton for 2 seconds.
6. The LED can light up in different ways.
▷ The LED lights up green: the program-
ming procedure is completed.
Release the button.
▷ The LED flashes fast: the hand-held
transmitter was detected but program-
ming is not complete.
Press the button on the interior mirror
for 2 seconds and release. Perform this
procedure three times to complete the
programming procedure.
If the integrated universal remote con-
trol remains nonoperational, continue
with the special features for change
code wireless systems.
▷ LED does not flash green after 60 sec-
onds: programming not completed.
Repeat steps 3 to 6.
If the programming procedure is not com-
pleted, the previous programming will remain
unchanged.
Operation
Warning
The operation of remote-controlled systems
with the integrated universal remote control,
such as the garage door, may result in injury,
for example, body parts becoming jammed in
a garage door. There is a risk of injury or risk
of damage to property. Make sure that the
travel path of the respective system is clear
during programming and operation. Also fol-
low the safety information for the hand-held
transmitter.
The system, such as the garage door, can be
operated using the button on the interior mirror
while the engine is running or when the ignition
is started. To do this, hold down the button
within receiving range of the system until the
function is activated. The interior mirror LED
stays lit while the wireless signal is being
transmitted.
Seite 200
CONTROLS Interior equipment
200
Online Edition for Part no. 01405A540A1 - II/22