BMW 8 Coupe Series, Руководство пользователя

Страница: 277 / 390

▷ Hand-held transmitter arrow 3; required for
programming.
Programming
General
1. Switch on standby state.
2. Initial operation:
Simultaneously press and hold the two outer
buttons on the rear-view mirror for approxi‐
mately. 10 seconds until the LED on the rear-
view mirror flashes green rapidly. All current
programming for the buttons on the rear-view
mirror is deleted.
3. Press the button on the rear-view mirror to be
programmed. The LED on the rear-view mir‐
ror flashes orange slowly.
4. Hold the hand-held transmitter for the system
to be operated approximately 2 to 8 cm, 1 to
3 in, away from the buttons on the rear-view
mirror. The distance required depends on the
hand-held transmitter.
5. Press and hold the button for the desired
function on the hand-held transmitter.
6. Release the buttons as soon as the LED
flashes green more rapidly or illuminates. The
green light indicates that the button on the
rear-view mirror has been programmed.
Flashing green more rapidly indicates that
this is an alternating-code radio system.
If the LED does not start to flash more rapidly
after a maximum of 60 seconds, change the
distance between the rear-view mirror and
hand-held transmitter and repeat the step.
Several attempts at various distances may be
necessary. Wait at least 15 seconds between
attempts.
7. To programme other functions on other but‐
tons, repeat steps 3 to 5.
The systems can be operated with the buttons
on the rear-view mirror.
Special instruction for alternating-
code radio systems
If the system cannot be operated after repeated
programming, check whether the system to be
operated is equipped with an alternating-code
radio system.
To do this, consult in the user manual of the sys‐
tem or hold down the programmed button on the
rear-view mirror for longer. If the LED on the
rear-view mirror first flashes rapidly and then illu‐
minates constantly for 2 seconds, the system is
equipped with an alternating-code radio system.
The flashing and illuminating of the LED are re‐
peated for approximately 20 seconds.
For systems with an alternating-code radio sys‐
tem, the integrated universal remote control and
the system must also be synchronised.
Please find information on the synchronisation in
the user manual of the system to be set.
To make synchronisation easier, enlist the assis‐
tance of a second person.
Synchronise integrated universal remote control
with system:
1. Park your vehicle within the range of the radio
remote-controlled system.
2. Program the corresponding button on the
rear-view mirror as described.
3. Locate and press the synchronisation button
on the system being set. The next step must
be carried out within approximately 30 sec‐
onds.
4. Hold down the programmed button on the
rear-view mirror for 3 seconds and then re‐
lease. Repeat this step as needed up to three
times to complete synchronisation. When
synchronisation is completed, the program‐
med function is run.
Seite 277
Interior equipment
CONTROLS
277
Online Edition for Part no. xxx - VI/18