BMW 8 Coupe Series, Руководство пользователя

Страница: 251 / 390

General
Road users hidden by obstacles at the side are
only detected very late from the driver's seat. To
improve the view, the cameras at the front and
rear show traffic in the areas at either side.
Yellow lines in the screen display indicate the
front and rear ends of the vehicle.
The camera image is subject to different levels of
distortion in some areas, and is thus not suitable
for estimating distances.
Display on the Control Display
Press the button with the engine running.
The image from the relevant camera is displayed,
depending on the driving direction:
▷ "Front": image from the front camera.
▷ "Rear": image from the rear camera.
Depending on the equipment, the crossing traffic
warning, see page
259 , can warn about ap‐
proaching vehicles by means of radar sensors.
With navigation system: activation
points
Principle
Positions at which the Panorama View is to
switch on automatically can be saved as activa‐
tion points provided that a GPS signal is being
received.
General
Up to ten activation points can be saved.
Activation points can be used for the front cam‐
era when driving forward.
Saving activation points
1. Drive to the position at which the system is to
be switched on, and stop.
2. Press the button.
3. Tilt the Controller to the right.
4. "Save activation point".
The current position is shown.
5. "Add point".
Activation points are, where possible, saved with
the town/city and street, otherwise with the GPS
coordinates.
Using activation points
The use of activation points can be switched on
and off.
1. Press the button.
2. Tilt the Controller to the right.
3. "Settings"
4. "Panorama View, GPS-based"
5. "Panorama View is displayed automatically
when set activation points are reached."
Displaying activation points
1. Press the button.
2. Tilt the Controller to the right.
3. "Show activation points"
A list of all activation points is shown.
Renaming or deleting activation points
1. Press the button.
2. Tilt the Controller to the right.
3. "Show activation points"
A list of all activation points is shown.
4. Select an activation point if necessary.
5. ▷
"Rename"
▷ "Delete point"
▷ "Delete all activation points"
Setting brightness and contrast
When Surround View or Panorama View is
switched on, it is possible to adjust the bright‐
ness and contrast.
Seite 251
Driver Assistance Systems
CONTROLS
251
Online Edition for Part no. xxx - VI/18