Blue Seal 203926, Руководство по обслуживанию

Страница: 42 / 76

-42-
Revision 7/F3527
© Moffat Ltd, November 2004
6.4.5 DOOR CATCH ADJUSTMENT
1) Open the control panel (refer 6.2.1).
2) Loosen the four screws securing the
chrome plated bar which carries the door
catches.
3) The door catches can now be adjusted in
or out to ensure that the door seals
correctly.
4) Tighten the screws and close the control
panel.
Actuator Arm
Figure 6.4.7
Figure 6.4.10
Figure 6.4.8
6.4.7 HOLD TEMPERATURE ADJUSTMENT
1) Open control panel (refer 6.2.1)
2) The hold temperature of the oven can be
adjusted by turning the hold thermostat
dial to the desired hold temperature.
Hold Thermostat
Dial
Figure 6.4.11
6.4.8 60 MINUTE TIMER ZERO POSITION
ADJUSTMENT
1) Remove 60 minute timer knob by pulling it
firmly away from control panel.
2) Open control panel (refer 6.2.1). Loosen
two screws on control panel holding 60
minute timer.
Two Screws
3) The timer can now be rotated as required
to ensure that the buzzer sounds at the
zero position.
Four Screws
6.4.6 DOOR ALIGNMENT
1) Loosen the three screws securing the
bottom hinge to the oven front.
Figure 6.4.9
2) Adjust hinge position to align door latch
with catch plate on side of door.
Three screws
6.4.9 BURNER INJECTOR ALIGNMENT
1) Remove burner access panel (refer 6.2.4).
2) To improve burner colour, an adjustment
of the gas/air mixture can be made by
adjusting the ‘set’ of the burner mixer tube
injector holder bracket. Using suitable
hand tools, raise or lower the injector
alignment slightly and determine best
position by viewing running burner colour
change.
3) In most cases this adjustment would only
be necessary after converting gas type or
when burner has a significant lack of
colour.