Blue Seal 203926, Руководство по обслуживанию

Страница: 35 / 76

-35-
Revision 7/F3527
© Moffat Ltd, November 2004
6.3.11 WATER SOLENOID
6.3.10 HOLD THERMOSTAT
6.3.13 SPRAY NOZZLE
1) Open control panel (refer 6.2.1) and undo
two screws securing hold thermostat
bracket.
2) Transfer wires to new thermostat.
3) Open oven door, remove racks and fan
baffle rack. Loosen thermostat phial
bracket
4) Withdraw old thermostat phial through
side of oven. Note position in phial
bracket
5) Insert new thermostat.
6) Re-assemble in reverse order.
NOTE: Ensure that the thermostat phials are
located in their correct positions. The
main thermostat probe must be on the
side closest to the door. The hold
thermostat must be on the side closest to
the fan (refer figure 6.3.13).
Figure 6.3.14
1) Ensure water supply is turned off.
2) To access the solenoid, remove the rear
access panel (refer 6.2.3)
3) To remove or replace solenoid,
disconnect water solenoid from oven
water tube behind water solenoid with a
1/2” (13mm) spanner.
4) Remove water solenoid from oven by
removing two screws securing the water
solenoid bracket to electrical supply
junction box.
Figure 6.3.15
Figure 6.3.16
1) Inside the oven remove the RH side fan
baffle, then unscrew the spray nozzle.
Figure 6.3.17
6.3.12 WATER SOLENOID CLEANING
1) Disconnect water supply from the water
solenoid.
2) Remove the sieve from the valve
assembly by pulling firmly away from the
assembly with a pair of pliers.
Sieve
4) Clean the sieve, removing all dirt and
grime.
5) Replace the sieve and reconnect the
water supply.
Two Screws
Two Screws
Two Screws
5) Carefully withdraw solenoid (including
wires and bracket).
6) Replace or service solenoid as required.
7) To reinstall, reverse procedure.
8) Check water connections do not leak.
9)
Check for correct water injection
operation.