BinTec X3200, Руководство пользователя

Страница: 50 / 419

50 BinTec Communications AG
Getting Started
3
➤
Click Next.
A message appears saying the router will reboot for a serial connection.
Making a serial
connection
➤
Click Next.
The Configuration Wizard establishes a connection to X3200 . After that
the router is restarted and the type of router identified: in your case, X3200 .
➤
Click OK and then Next.
Selecting
configuration options
➤
Select one or more of the following options:
– Basic Router Configuration, for making the basic router settings
( chapter 3.5.1, page 51 ).
– Internet Connection, for configuring your Internet access
( chapter 3.5.2, page 55 ). You can configure the Internet access either
as high-speed access via ADSL or, if you wish, as conventional access
via ISDN.
Configuration with the Quick Mode is sufficient in many cases. You can use
Expert Mode to optimize an
X3200 configuration you have created in Quick
Mode.
However, if you first use Expert Mode and then Quick Mode, the complete con-
figuration will be overwritten and the previous configuration in Expert Mode will
be lost.
If the Configuration Wizard cannot establish a connection or an error message
appears:
➤
Make sure X3200 is correctly connected.
➤
Check to see if a terminal program (e.g. HyperTerminal) or another pro-
gram is running and occupying the serial interface. If yes, close the pro-
gram.
➤
Check if X3200 ´s baud rate has changed. The ex works setting is 9600 bps.
If you have changed the baud rate, set it to 9600 bps again or use the Con-
figuration Wizard in Expert Mode.
➤
If the Configuration Wizard could not boot X3200 , switch X3200 off and
then on again. Wait until the LEDs stop blinking.
➤
Click Next.