Binder MKF 115, Руководство по эксплуатации

Страница: 31 / 115

MKF+ MKFT (E3.2) 07/2017 page 31/115
CAUTION
Danger of overheating.
Damage to the voltage and frequency changer.
∅
Do NOT install the voltage and frequency changer in unventilated recesses.

Ensure sufficient ventilation for dispersal of the heat.
The voltage and frequency changer is equipped with four castors. The rear castors can be easily locked
via the attached brakes
4.8 Electrical connection
4.8.1 Information on connecting the alternating climate chamber
The chambers are supplied ready for connection. They come with a fixed power connection cable of 2700
mm /
8.9 ft in length and are equipped with3 internal overload releases against excess-current.
Model Power plug
Nominal voltage
±
10% at the
indicated power frequency
Current
type
Chamber
fuse
MKF 115
MKFT 115
MKF 240
CEE plug 5-poles, 16 Amp 400 V at 50 Hz 3 N~
16 Amp
3 x internal
MKFT 240 CEE plug 5-poles, 16 Amp 400 V at 50 Hz 3 N~
16 Amp
3 x internal
MKF 720
MKFT 720
CEE plug 5-poles, 32 Amp 400 V at 50 Hz 3 N~
25 Amp
3 x internal
•
The domestic socket must also provide a protective conductor. Make sure that the connection of the
protective conductor of the domestic installations to the chamber’s protective conductor meets the lat-
est technology. The protective conductors of the socket and plug must be compatible!
•
Prior to connection and start-up, check the power supply voltage. Compare the values to the specified
data located on the chamber’s type plate (left chamber side, bottom right-hand, chap. 1.4)
•
When connecting, please observe the regulations specified by the local electricity supply company and
as well as the VDE directives (for Germany). We recommend the use of a residual current circuit
breaker.
•
Pollution degree (acc. to IEC 61010-1): 2
•
Over-voltage category (acc. to IEC 61010-1): II
CAUTION
Danger of incorrect power supply voltage.
Damage to the equipment.

Check the power supply voltage before connection and start-up.

Compare the power supply voltage with the data indicated on the type plate.
See also electrical data (chap. 20.4).
To completely separate the chamber from the power supply, you must disconnect the power
plug. Install the chamber in a way that the power plug is easily accessible and can be easily
pulled in case of danger.