Binder MKF 115, Руководство по эксплуатации

Страница: 30 / 115

MKF+ MKFT (E3.2) 07/2017 page 30/115
Check: Quickly open the water tap while there is no chamber connected – the valve should cut off the
water flux without any delay.
4.7 Installation of the voltage and frequency changer
(chambers with voltage and frequency changer)
The voltage and frequency changer is supplied packed separately together with the chamber.
CAUTION
Sliding or tilting of the voltage and frequency changer.
Damage to the voltage and frequency changer.
Risk of injury by lifting heavy loads.
∅
Do NOT lift the voltage and frequency changer by hand.

Lift the voltage and frequency changer from the pallet using technical devices (fork
lifter). Set the fork lifter only from the rear in the middle of the chamber.

Alternatively, the voltage and frequency changer can also be lifted at the eyelets on
the top by means of a lift truck
(a) Eyelets for lifting with a lift truck
(b) Positions for a forklift
Figure 12: Positioning of aids for lifting the voltage
and frequency changer
For the installation of the voltage and frequency changer behind the chamber, provide a rear wall dis-
tance of the chamber of approx. 1 m /
3.3 ft .
If possible, fix the voltage and frequency changer at the chamber. For this purpose, an Allen key size 4 is
required. Connect the slots at the end of the chassis with two M6 screws to the threads provided below
on the rear panel of the chamber (see Figure 13).
(a)
(b)
(a)
(b)