Bennett Marine
| Bolt Electric Trim Tab System
13
continued
Actuator & Tab Installation
Mounting Fixed Upper
Hinge Actuators (BEA2000)
to the Transom.
• Temporarily detach the actuator
from the lower hinge by
unscrewing the 1/4-20 x 3/4 screws.
• Carefully insert the end of the
electrical wires though the
wire hole in the transom.
• Apply 3M 5200 waterproof sealant
on the mounting surface and
around the wiring of the new
actuator.
• Mount the upper hinge of the new
actuator to the transom using the
supplied #14 x1- 1/2" screws with a
#3 Phillips head screw driver.
• Re-install the lower hinge mount to
the trim tab using the (2) supplied
1/4-20 x 3/4" and a #3 Phillips
head screwdriver.
Do not use a power screw driver.
• On the inside of the transom,
install the wiring connector onto
the wires:
»
Insert the white wire into
location pin #1, insert the
black wire into location pin #2
into the back of the connector
until the pin locks into place.
»
Install the orange wedge into
the front of the connector.
»
Ensure the proper wire color
is on the correct side of the
connector.
»
For help with connectors visit
BennettTrimTabs.com/
ConnectorHelp.
White(#1)
Black(#2)
