continued
Helm Control Installation
BRC BOLT Rocker Control (BRC4000)
Refer to wiring diagrams and installation templates
beginning on page 24. The relay module installation on
(page 21) is not required when using this control option.
• Before drilling any holes, read the entire
instructions. Before performing any electrical work
on a vessel, disconnect the battery by removing the
positive (+) cable or if equipped, turn the battery
disconnect switch to the OFF position.
• Using the included template (Pg. 28), mark
the locations for the 7/64" mounting holes
and the 2.5" center hole.
• Check carefully ensure there are no obstructions behind the console before drilling.
• Using a 2.5" diameter hole-saw, drill the center hole. Use a 7/64" drill for the four
mounting stud holes.
• Unsnap the bezel from the control plate.
• Remove the four (4) #8 screws from the hardware bag and insert into the holes on
each corner of the control plate.
• Place the control plate onto the console, feeding the pre-connected wires through
the 2.5" center hole while inserting the screws into each of the four holes.
• Once the control plate is properly seated, screw down the four (4) #8 screws
(do not over-tighten) and snap the bezel back onto the plate assembly.
• The port cable on the rocker switch is marked with a red band. The starboard
cable on the rocker switch is marked with a green band. Note: After the actuators
are installed, the port cable (red band) will be connected to the extension cable
coming from the port actuator, conversely the starboard cable (green band) will be
connected to the extension cable coming from the starboard actuator.
• Plug the port black/white 20ft. extension cable
(PN# BAW20XX) to the port connector on the BRC Rocker Control.
• Plug the starboard black/white 20ft. extension cable
(PN# BAW20XX) to the starboard connector on the BRC Rocker Control.
• Connect the orange wire from the rocker switch to (+) 12V (20A) power and black
wire to ground. Turn the battery on.
• For troubleshooting, see page 33
Bennett Marine
| Bolt Electric Trim Tab System
18