Control Testing/Diagnostics
System Startup
• Turn the battery switch back on or reconnect the battery.
• Turn on the gauge switch.
• Turn on the ignition switch.
• Control should power up and the red power LED should be illuminated.
• The green communications LED should be flashing.
• Press the port "Bow Down" button. The starboard red LEDs should illuminate
as the port actuator extends.
• Press the starboard "Bow Down" button. The port red LEDs should illimunate
as the starboard actuator extands.
• Press the port "Bow Up" button. The starboard red LEDs should turn off as the
port actuator retracts.
• Press the starboard "Bow Up" button. The port red LEDs should turn off as the
starboard actuator retracts.
• If the system is not functioning as described above, refer to the troubleshooting
section beginning on page 33.
Port (left)
actuator should
extend when
pressed
Port (left) actuator
should retract
when pressed
Yellow LEDs
Yellow LEDs
Starboard (right)
actuator should
extend when
pressed
Starboard (right)
actuator should
retract when pressed
PORT
DOWN
DOWN
UP
UP
STBD
Bennett Marine
| Bolt Electric Trim Tab System
23
