Relay Module Installation
Installation Steps
Note: Relay module installation is not required for BRC installations
(See wiring diagram beginning on page 24).
• Find a suitable dry location
• Mount the relay module under the helm using the mounting hardware
(2 #8 x 1/2"screws provided) to secure it in place.
• Connect ground (black wire) to ground bus.
• Connect power (orange wire) to a supply capable of a 20A (12V), or 10A (24V).
• Plug the 3 ft. extension cable on the display to the 3 ft. extension cable on the
BCN relay module (If cable length is not long enough, an extension is available
as part number BHW40XX).
Green Communications LED
Red Power LED
Starboard actuator up
(black), down (white)
Port actuator up (black),
down (white)
BCN6500
Bennett Marine
| Bolt Electric Trim Tab System
21
