Benelli 2014 BN600, Руководство по обслуживанию

Страница: 104 / 243

CHAS
- 103 -
Fitting:
Follow the assembly sequence shown below:
WARNING
Before installing, clean all of the internal parts of the brake, and
lubricate them with clean or new brake fl uid.
Never use solvents on the internal parts of the brake.
• Fit the microswitch (16) by screwing the screw (13) and the
washer (14) to the pump body, with the following torque.
T.R.
Torque 1.5 N*m
• Insert the “X” connection of the front brake microswitch (16)
Fig.A.
• Assemble the special screw (9) and the relevant gaskets
(5) to the front brake hose(2) and apply it to the pump body.
Tighten the screw to the following torque:
T.R.
Torque 26 N*m
WARNING
To guarantee the safety of the bike, it is essential for the path of
the brake hose to be correct.
• Assemble the front brake lever (15) by tightening the nut
(12) and the fastening screw (10) to the following torque:
T.R.
Torque 7 N*m
• Fit the bracket (17) to the handlebar and tighten the two
fastening screws (8), fi rst the top and then the bottom, to
the following torque:
T.R.
Torque 8 N*m
NOTE
Install the brake pump support with “UP” facing upwards “A” Fig.
B.
Bring the end of the brake pump check element into line with the
mark “B” on the right grip of the handlebar FigB.
NOTE
Once these operations are completed, top up with brake fl uid.
See chapter 3 “inspections and periodic maintenance”, “frame/
front brake fl uid check/topping up”.
Position Description Quantity
20 DRAIN 1
21 DRAIN PLUG 1
FRONT AND REAR BRAKES
FRONT BRAKE PUMP INSTALLATION
A
X
B
A
B