COOL
- 240 -
RADIATOR
RADIATOR REMOVAL/FITTING
Position
Description
Quantity
20
RUBBER VIBRATION DAMPING PAD
1
21
PIPE
1
22
THERMAL PROTECTION
1
23
CLIP
2
IMPORTANT NOTICE
Remove coolant before carrying out these steps.
Removal:
1. Remove the connecting pipe (18*) , loosening the clip (19*)
Fig.A
NOTE
The numbers marked (*) are shown in the replacement parts
table in Chapter 6 “COOLING CIRCUIT” “radiator removal/fi tting”
paragraph PIPES(*).
After taking off the two top outer fairings on the right and
left:
2. Remove the two screws (1**-12**) fastening the radiator
to the frame. Fig.B e and the fastening screw (12**) on the
opposite side Fig.C
3. Remove the clamp fastening the hose (10**) Fig. D
NOTE
The numbers marked (**) are shown in the replacement parts
table in Chapter 6 “COOLING CIRCUIT” “radiator removal/fi tting”
paragraph RADIATOR (**).
Check:
•
the radiator fi ns.
In the event of obstruction, clean.
Use a jet of compressed air to the rear section
of the radiator.
In the event of damage, repair or replace.
NOTE
Straighten any fi
ns with a fi ne, fl athead screwdriver.
Check:
•
the radiator hoses.
•
the radiator pipes.
If there is any cracking/damage, replace.
Check:
•
the radiator vent (19**)
In the event of damage, replace.
If operation is faulty, check and
repair.
A
18*
19*
B
1**
12**
C
12**
D
10**
Содержание 2014 BN600
