Benelli 2014 BN600, Руководство по обслуживанию

Страница: 127 / 243

- 126 -
CHAS
HANDLEBAR
HANDLEBAR INSTALLATION
Proceed to install, following the steps for removal in reverse
order, but taking care to observe the instructions below:
Fit:
• The switch on the right (5) and left (8) handlebars, taking
care to align the projecting part “A” of the switch with the
hole “B” on the right and left handlebars Fig. E.
• The brake clevis (17) Fig.B tightening the two screws (8) to
the following torque:
T.R.
Torque 8 N*m
NOTE
Install the brake pump clevis with “UP” facing upwards Fig. F
Tighten the top screw and then the bottom one.
Line up the coupling surfaces of the brake pump clevis retainer
with the punching on the right handlebar.
There must be a gap of 2 mm between the switch on the right
handlebar and the brake pump clevis.
Assemble:
• The handlebar grip
Apply a fi ne layer of rubber-based adhesive on the end of the
handlebar.
Slip the grip over the end of the handlebar grip.
Remove all traces of excess rubber-based adhesive with a clean
rag.
IMPORTANT NOTICE
Do not touch the handlebar grip until the rubber-based adhesive
has dried completely.
Assemble:
• The handlebar
• During the handlebar assembly, take care to place the
handlebar in the position shown in Fig.G, at the fourth refe-
rence mark(X).
• Insert a 0.5 mm thickness gauge (Y) between the clamp
and the plate in the top section Fig. G and position the two
top screws (A).
• Tighten the back two screws (A) to 15 N*m and then to 22
N*m.
• Remove the thickness gauge.
• Tighten the front two screws (A) to 15 N*m and then to 22
N*m.
Tighten:
• The four fastening screws (A) of the handlebar clevis (B)
Fig. G to the following torque:
T.R.
Torque 20 N*m
E
A
B
F
UP
17
G
X
A
B
Y