Benelli 2014 BN600, Руководство по обслуживанию

Страница: 46 / 243

CHK
ADJ
- 45 -
Removal:
1. Remove the passenger seat, using the wrench provided and
remove the rider's seat with the release knob (A) Fig, A.
2. Remove the side fairings from the tank and fuel tank.
3. Remove the two screws fastening the plates (7-8) securing
the fi lter body to the frame. Fig.B
4. Loosen the two screw clips (11) and separate the fi lter body
from the throttle valves.
5. Place the fi
lter on a fl at surface.
6. Remove the 11 screws (1) fastening the cover (2) Fig. B.
7. Take out the fi lter element (4) Fig, C.
NOTE:
Replace the air fi lter element every 12,000 km. If the vehicle is
used in particularly damp or dusty climates, it will be necessary
to change the air fi lter more often.
Check:
To make sure there is no damage to the air fi lter. If damaged, it
will need to be replaced and if intact, proceed to wash:
1. Wash the fi lter element with specifi c solvents for this pur-
pose.
2. Air dry.
3. Apply a specifi c oil to the whole surface of the fi lter element.
NOTE:
Before fi tting the fi lter element into the air box., be sure to drain
off any excess oil and make sure that it is no longer dripping.
Installation:
1. During the installation stage, follow the steps for removing
the fi lter, as described above, only this time in reverse order.
IMPORTANT NOTICE:
Never start the engine without the air fi lter installed. If not
fi ltered, air will cause engine parts to wear out quickly and may
even damage the engine. Using the engine without air fi lter
will also have a negative effect on the fi ne tuning of the throttle
valves and this in turn will cause the engine's performance to
suffer and even to eventually overheat.
Make sure that the air fi lter is always in good working order.
The lifetime of the engine depends mainly on this part.
B
A
1
ENGINE/AIR FILTER
AIR FILTER REMOVAL/FITTING
2
7 8
A
C
4