Benelli 2014 BN600, Руководство по обслуживанию

Страница: 238 / 243

COOL
- 237 -
Removal:
1. Remove the connection pipes (10*) and (13*) of the distribu-
tor (3*), loosening the clips (9*) Fig. A
NOTE
The numbers marked (*) are shown in the replacement parts
table in Chapter 5 “Cooling circuit” chapter, “radiator removal”
section.
2. Remove the screw (5*) fastening the distributor (3*) and
gasket (4*) Fig.B.
Check:
• visually inspect the distributor for any build up or breakages
If there is any damage/breakage, replace.
Fitting:
1. Assemble the screw (5*) and gasket (4*) to the distributor
(3*)
2. Tighten the screw (5*) to the following torque:
T.R.
Torque 60 N*m
NOTE
The numbers marked (*) are shown in the replacement parts
table in Chapter 5 “Lubrication circuit” .
3. Connect the connection pipes (10*) and (13*) of the distribu-
tor (3*), tightening the clips (9*) Fig. A
NOTE
If not worn, re-use the clips previously removed, otherwise
replace them.
10*
9*
13*
9*
5*
3*
4*
A
F
HEAT EXCHANGER
HEAT EXCHANGER REMOVAL/FITTING