- 183 -
ENG
INLET CAMSHAFT FITTING
HEAD TIMING GEAR
Keep the relevant tool* inside the spark plug hole, as described
previously, to check the TDC Fig. A.
(*) Engine tuning tool
Code:......................
Once the TDC for the cylinder 1 has been established, proceed
to assemble the inlet camshaft.
NOTE
During this assembly, it is important for the shaft lobes to be
placed inwards, Fig.B and the two reference notches X of the
distribution gear to be in line, as in the fi gure.
NOTE
When assembling the underframes, it is necessary to add spe-
cial grease Fig. C, to prevent the shafts from turning dry when
the engine is fi rst started.
Place the underframes according to the sequence previously
shown in the removal stage, and tighten the fastening screws
Fig. D to the following torque:
T.R.
Torque 6-13 N*m
Use special grease to secure the screws.
A
B
X
C
D
Содержание 2014 BN600
