Benelli 2014 BN600, Руководство по обслуживанию, Страница: 180 / 243

- 179 -
ENG
HEAD TIMING GEAR COVER REMOVAL
HEAD TIMING GEAR
As soon as the timing gear cover (10) has been lifted, take care
with the removal of the cover seal (14) Fig.E.
NOTE
If the timing gear cover seal (10) should be broken, it must be
replaced with an original
When the cover is being refi tted, it is necessary to apply sealant
paste to the surface of the gasket, as shown in red in Fig.F
E
14
F
REMOVAL OF THE DISTRIBUTION CHAIN TENSIONER
Take out the chain tensioner (25), loosening the tensioner screw
“A”, recovering the spring and washer, followed by the two
tightening screws (26) Fig. G.
NOTE
Operation to perform with the engine in TDC.
During the refi tting stages, take care to ensure that the gasket
(23) Fig. H is not worn or damaged and if this is not the case,
replace it.
Bring the tensioner to the retracted position before inserting it in
its housing.
To secure the tensioner to the cylinder body, it is necessary to
tighten the two screws (26) with the following torque:
T.R.
Torque 10 N*m
Use Loctite thread locker to secure.
Use the relevant tool* to keep the tensioner retracted, Fig.I and
proceed to secure the screw “A” with the following torque:
T.R.
Torque 10 N*m
(*) Tool .............................
Code:......................
G
A
26
H
23
I
10