Section 6. Operating and Adjusting Regulations
Belarus 80.1/80.2/82.1/82.2/82
Р — Operation and Service Manual
43
6.8.7. Draft (Position) Control System
Adjustment
Draft (Position) Control System Adjust-
ment
should be made as follows:
1. Remove the side console cover.
2. Adjust the length of rod 16 (see Fig.
28), so that shifting backward (if
viewed in the direction of the tractor
travel) of the selector-arm results in a
18-24 mm gap between the rubber
roller located on the arm and the sector
edge (see Fig. 25).
Adjustment of the Position Rod
should
be made as follows:
а) set the selector-arm (1)into the mid-
position;
b) raise the hitch linkage to its extreme
upper position;
c) adjust the length of rod 4, so that the
arm (1) is free to enter the slot of the
position control lever (2). Then
shorten the rod (4) by 1 turn of ad-
justing nuts (7);
Fig. 28
