Belarus 80.1/80.2/82.1/82.2/82
Р — Operation and Service Manual
Section 7. Maintenance Procedures
83
7.2.1. Seasonal Maintenance Services (MS-SS and MS-03)
Overlap operations of Seasonal Maintenance Services with those of Maintenance Ser-
vice Schedule next in turn (refer to Table 9).
Table 9
Scope of operations performed
When preparing for autumn-winter operation (at
standing average daily temperature of below + 5°
С)
When preparing for sprin-summer operation (at
standing average daily temperature of above, or
equal to, + 5°
С)
Change oil summer-grades for winter-grades (refer
to Table on Lubricants and lubrication Chart):
Change oil winter -grades for summer -grades
in diesel-engine crankcase;
in diesel-engine crankcase;
in hydraulic unit housings;
in hydraulic unit housings;
in hydraulic steering booster
руля;
in hydraulic steering booster
руля;
in transmission housings;
in transmission housings;
in FDA housing;
in FDA housing;
in FDA wheel-hub reducing gears;
in FDA wheel-hub reducing gears;
in intermediate bearing support;
in intermediate bearing support;
in hub reducing gears of tractors Belarus-82
Р.
in hub reducing gears of tractors Belarus-82
Р.
Drive in the seasonal voltage adjustment screw on the
alternator to a stop (position «Z»
— winter)*.
Set the seasonal adjustment screw on the alterna-
tor into position «L»
— summer*.
Change lubricant in front wheel hubs on tractors
Belarus-80.1/80.2.
Adjust clearance in wheel bearings.
Fill in the diesel-engine cooling system with anti-
freeze for low temperatures, first flushing the cooling
system.
Clean calibrated hole in coupling bolt of the electrical
torch pre-heater.
Remove propeller shafts, check flanges for tightness in
axial direction on the transfer box shafts, intermediate
bearing support and main drive pinion (for tractors
equipped with a FDA). Take up axial backlashes by
retightening nuts.
*
)
If the adjusting screw available on the alternator.
7.2.2. Oil and Fuel Holding Capacities, l
Diesel-engine lubrication system (incl. oil radiator)
13.3
Diesel-engine cooling system (incl. radiator)
17
Transmission housing
40
FDA housing with bevel reducing gearings (tractor Belarus-82.1)
1.6
FDA housing with planetary-and spur reducing gears (tractor Belarus-82.2)
3.7
FDA reduction gear housing with bevel reducing gearings (each)
1.8
Upper bevel gear pair in FDA reduction bevel gearbox (each)
0.3
Planetary-and spur reducing gearbox housing (each)
2.0
Hydraulic system and HSCU oil tank
21.5
Fuel tanks (2 pcs)
130
FDA universal-joint drive in the intermediate bearing support housing
0.15
HSB casing
6.0
Wheel-hub drive housing, tractor Belarus-82
Р (each)
3.7
