Section 6. Operating and Adjusting Regulations
Belarus 80.1/80.2/82.1/82.2/82
Р — Operation and Service Manual
43
Setting Wheeltrack of the Belarus 82.1
Tractor, Equipped with a FDA Fitted with
Hypoid Reducing Gears
The front wheel track on the tractor
equipped with a hydrostatic steering con-
trol unit is adjusted in a stepwise man-
ner: by extending the upper bevel gear
pair assemblies, repositioning of the cyl-
inder in bracket holes and wheels turn-
round with simultaneous switching from
side to side.
IMPORTANT!
When
switching
the
wheels, pay special attention to that the
direction of wheel rotation agree with the
direction of the arrow on the tyre
sidewall.
In the course of adjustment by extension
of the hypoid gear pair assemblies check
to see that the left-hand and right-hand
bodies be extended to the same amount.
The distance between the hole in the
bracket to receive the cylinder collar pin
is 55 mm, thus, providing for a wheel-
track change to either side (decreasing
or increasing) from its middle position, at
a 110 mm interval.
ATTENTION!
Following changes in
wheeltrack, it is imperative that front
wheel toe-in be adjusted. Tighten up the
wheel-to-hub fastening nut at a torque of
200…250 N•m, the nuts of disks-to-rim
bracket at a torque of
180…240 N•m.
