Belarus 1822.3, Руководство оператора

Страница: 46 / 358

2022.3-0000010 OM
45
2.15 Lift linkage controls
2.15.1 General information on rules of rear lift linkage control
The RLL is controlled with the control panel 31 (figure 2.1.1) and remote buttons 4
and 5 (figure 2.15.3). If there are failures in RLL electronic-hydraulic control system a di-
agnostics annunciator 9 (figure 2.15.1) displays information on the failure and, if neces-
sary, operation of RLL control system is blocked.
2.15.2 RLL control panel
RLL control panel, located on a side console in tractor cab, is presented in figure
2.15.1.
1 – handle to adjust speed of lowering; 2 – handle to select control method; 3 –
handle to adjust height limit of linkage uplifting; 4 – handle to adjust depth of soil tillage; 5
– annunciator of linkage uplifting (red color); 6 – annunciator of linkage lowering (green
color); 7 – handle to control RLL; 8 – retainer of blocking of RLL control handle; 9 – trou-
bleshooting annunciator (red color); 10 – button to engage “dampening” mode; 11 – an-
nunciator of “dampening” mode activation (orange color).
Figure 2.15.1 – RLL control panel
Order of RLL control is the following:
- set a method of control depending on operation character using the handle 2 (figure
2.15.1). Turning of handle clockwise against the stop – position method of control; contra-
clockwise against the stop – draft control, in between – combined control, the combined con-
trol is preferential;
- set a required height of implement uplifting in transport condition with the handle 3.
Turning the handle clockwise against the stop corresponds to max. uplifting, contraclock-
wise against the stop - to min. uplifting;
- set tillage depth with the handle 4. Turning the handle clockwise against the stop
corresponds to min. depth, contraclockwise up to “A” position corresponds to max depth;
turning of the handle contraclockwise against the stop corresponds to floating position;
- lower the linkage moving the handle 7 to a lower fixed position.
Then during operation it is required to adjust a trailed implement for optimal opera-
tion conditions:
- with the handle 2 – combination of control means;
- with the handle 4 – depth of soil tillage.
- with the handle 1 – speed of RLL lowering and uplifting. Turning of the handle
clockwise against the stop corresponds to the max. speed of lowering (uplifting), turning the
handle contraclockwise corresponds to min. speed of lowering (uplifting).
The handle 7 has four positions:
) middle position – disengaged;
b) upper position – uplift;
https://tractormanualz.com/