Belarus 1822.3, Руководство оператора

Страница: 223 / 358

2022.3-0000010 OM
222
5.12.5 Procedure of filling with water or water solution
Filling in of the liquid shall be carried out in the following order:
- jack the tractor;
- round the wheel 2 (Figure 5.12.1) in such way that the vent 1 is in the above posi-
tion;
- screw out the spool and insert in its place a compound “air-water” vent 2 (Figure
5.12.2), through which simultaneous filling in with water (solution) and tire venting is car-
ried out;
- perform filling in with water (solution);
- after filling in, withdraw the compound vent and screw in the spool, meanwhile ad-
just pressure to the standard tire operating pressure.
ATTENTION: WATER (SOLUTION)-FILLED TIRES PRESSURE SHALL BE
CHECKED ONLY WHEN THE VENT IN THE ABOVE POSITION OTHERWISE THE WA-
TER ENTERING THE TIRE PRESSURE GAUGE CAN RESULT IN PRESSURE GAUGE
FAILURE!
ATTENTION: FILL IN LIQUID ONLY INTO THE INNER TIRES OF THE DOUBLED
WHEELS AND FOR NOT MORE THAN 40% OF THE TIRE VOLUME!
1 – vent; 2 – wheel.
Figure 5.12.1 – Position of the wheel during filling up of the liquid
1 – tire; 2 – compound “air-water” vent
Figure 5.12.2 – Liquid filling-up scheme
5.12.6 Order of partial water or water solution drain from the wheels tires
For partial liquid drain the following shall be carried out:
- unload the wheel with liquid – jack the wheel in order it not to touch the ground;
- set the wheel in such a way that the vent is in the bottom;
- screw out the spool and drain the water or non-freezing solution up to the level of
vent positioned at the bottom.
https://tractormanualz.com/