Baroness GM2810, Руководство по обслуживанию

Страница: 147 / 185

Remove collar from the wheel shaft.
1
2
ndx9vc-003
Inspection of Front Roller_003
1 Wheel shaft
2 Collar
Important
Be sure to replace the bearing with new one.
Have new bearings, and apply a profuse
amount of grease.
1
2
1lbr3a-008
Inspection of Front Roller_004
1 Bearing
2 Oil seal
Caution
See the list in "Tightening torques" (Page
3-5) .
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening, etc.
Install the front roller ass'y following the
reversed procedure of the procedure 2 to 5.
Make sure that the roller rotates smoothly
with no play when the roller shaft is fixed.
Apply grease. (See "Greasing Points"
(Page 3-12) .)
5.
6.
7.
8.
9.
Install the front roller ass'y. (See
"Installation of Front Roller Assembly"
(Page 7-11) .)
Inspection of Rear Roller
Wear of bearings due to frequent usage and
invasion of water may damage bearings to
prevent smooth rotation of the roller. Inspect
and replace the parts such as the oil seal,
bearings.
Make sure that there is no abrasion or
adhesion of the roller.
Make sure that there is no wear of the roller
shaft.
Make sure that there is no wear or damage
of the oil seal.
Make sure that there is no wear or rust of
the bearing.
Make sure that there is no play in the fit of
the roller and the bearing.
Danger Danger
The rotary knife is an edged tool.
Handle it carefully, since it could cut your
hands or legs.
Caution
When touching edged tools, wear gloves,
since they could cut your hands.
Remove the rear roller ass'y. (See
"Removal of Rear Roller Assembly" (Page
7-12) .)
Caution
Pay attention not to damage the threads when
you hit the shaft with a hammer.
10.
･
･
･
･
･
1.
Operating Machine and Mower Units
GM2810
Operating Machine and Mower Units
Page 7-29
Inspection and repair of each section