Baroness GM2810, Руководство по обслуживанию

Страница: 146 / 185

Evenly tighten bolts A and B, little by little,
until the housing is securely installed.
3
1
2
2
1lbr3a-016
Inspection of Housing_018
1 Bolt A
2 Bolt B
3 Housing
Roller
Inspection of Front Roller
Wear of bearings due to frequent usage and
invasion of water may damage bearings etc.
and prevent smooth rotation of the roller.
Inspect and replace the parts such as the
bearings.
Make sure that there is no abrasion or
adhesion of the roller.
Make sure that there is no wear of the roller
shaft.
Make sure that there is no abrasion or
deformation of the collar, or washer etc. on
both ends.
Make sure that there is no wear or rust on
the bearing.
Make sure that there is no play in the fit of
the roller and the bearing.
Danger Danger
The rotary knife is an edged tool.
Handle it carefully, since it could cut your
hands or legs.
Caution
When touching edged tools, wear gloves,
since they could cut your hands.
19.
･
･
･
･
･
Remove the front roller ass'y. (See
"Removal of Front Roller Assembly" (Page
7-10) .)
Caution
Pay attention not to damage the threads when
you hit the shaft with a hammer.
Knock one end of the wheel shaft with a
plastic hammer to push out the shaft.
1
2
ndx9vc-001
Inspection of Front Roller_001
1 Wheel shaft
2 Plastic hammer
Remove collar, washer, and bearing from
one end of the shaft.
1
1
2
2
3
3
ndx9vc-002
Inspection of Front Roller_002
1 Collar
2 Washer
3 Bearing
Follow the same steps to remove them from
the other side.
1.
2.
3.
4.
GM2810
Operating Machine and Mower Units
Page 7-28
Inspection and repair of each section