Baroness GM1700, Руководство по обслуживанию

Страница: 151 / 192

Use an iron pipe, etc. and tap it with a
plastic hammer to remove the bearing.
1
5ymvks-003
Inspection of Center Deck Housing_003
1 Bearing
Remove the collar.
1
5ymvks-004
Inspection of Center Deck Housing_004
1 Collar
Use an iron pipe, etc. and tap it with a
plastic hammer to remove the bearing.
1
5ymvks-005
Inspection of Center Deck Housing_004
1 Bearing
Important
Be sure to replace the bearings and oil seals
with new ones.
7.
8.
9.
Apply a profuse amount of grease to the
lip of the oil seal.
1
5ymvks-006
Inspection of Center Deck Housing_005
1 Oil seal
For installation, reverse the removing
procedure.
Note:
Use a driver to drive in the oil seal and
bearing.
Inspection of Left and Right Deck Housings
Wear of bearing due to frequent use and/or
damage of bearing etc. caused by invasion
of water may prevent smooth rotation of the
rotary knife. Inspect and replace the parts
such as the oil seal or bearing.
Make sure that the housing does not have
any chips or cracks.
Make sure that there is no wear or
damage of the shaft.
Make sure that there is no wear or
damage of the oil seal.
Make sure that there is no wear or rusting
of the bearing.
Make sure that there is no play in the fit of
the shaft and the bearing.
Remove the mower unit from this
machine. (See "Removal of Mower Unit"
(Page 7-9) .)
Remove the rotary knife. (See "Change of
Rotary Knife" (Page 7-24) "Contour Deck"
(Page 7-10) .)
Remove the belt. (See "Removal of Belt"
(Page 7-12) .)
Remove the left and right deck housings.
(See "Removal of Left and Right Deck
Housing" (Page 7-13) .)
10.
11.
￭
･
･
･
･
･
1.
2.
3.
4.
Operating Machine and Mower Units
GM1700
Operating Machine and Mower Units
Page 7-35
Contour Deck