English
3.6 Connecting and Disconnecting the Probes
To connect a probe,
1.
Place the probe into one of the Site~Rite IV Probe holders located on the side arm.
2.
Insert the probe connector into the probe port on the rear of Site~Rite IV Scanner. When
properly inserted, the connector clicks into place.
Note:
The Probe connector can only be inserted in one direction. If the connector does not fit
into the probe port, turn the connector over and try again.
Caution:
Do not force the Probe connector. Damage to the connector and system could result.
3.
Tug lightly on the connector to verify that the connection is snug.
To disconnect the probe,
1.
If the system power is on, power off Site~Rite IV System by pressing the power button on the
front of the scanner.
2.
Press the sides of the probe connector.
3.
Gently pull the connector away from the back of Site~Rite IV Scanner.
For information about probe types and handling, see Chapter 5,
Site~Rite IV Probes
.
For more information about probe specifications, see Chapter 10.2,
Site~Rite IV Probes Specifications
.
3.7 Powering On the Scanner
To power on Site~Rite IV System, do the following:
1.
Verify that a probe is properly connected to the Site~Rite IV Scanner. A probe must be
connected to the scanner for the system to power on.
2.
Press the power button located on the front of the Site~Rite IV Scanner.
A green light illuminates inside the power button.
3.
Wait approximately 10 seconds for the display screen to illuminate.
To power off the Site~Rite IV System, press the power button again. The system is powered off when
the display screen darkens and the green light inside the button turns off.
Site~Rite* IV Ultrasound System Operator’s Manual
Chapter 3: Setting up the Site~Rite* IV System
1
Identifier
Probe Port
1
Label
Содержание Site-Rite IV
Страница 2: ...Site Rite IV Ultrasound System Operator s Manual...
Страница 3: ......