Bard Site-Rite IV, Руководство пользователя

Страница: 10 / 36

­
Site~Rite* IV Ultrasound System Operator’s Manual
Chapter 3: Setting up the Site~Rite* IV System
roll stand from moving.
Attaching the Wire Basket
To attach the wire basket,
1. Place the basket against the roll stand post,
about a third of the way from the top of the
post. The open side of the basket faces up.
2. Position the two curved mounting clamps
around the post so that the holes in the
clamps align with those on the wire basket
mounting plate.
3. Use the Phillips head screwdriver to screw the
inch-long screws through the mounting clamp
holes and into the wire basket mounting plate.
4. Tighten all of the screws. There are two screws per mounting bracket.3
Attaching the Side Arm
To attach the side arm,
1. Use the Allen wrench to unscrew the clamp screws.
2. Position and hold the side arm on the roll stand post, just below the adjustment lever (or
knob), so that the side arm projects to your right when you face the front of the roll stand.
The additional probe and cord holder face toward the back of the roll stand.
3. Position the side arm clamp around the roll stand post, so that the screw holes in both the
side arm and the clamp align.
4. Use the Allen wrench to loosely screw both of the Allen screws through the clamp and into
the side arm.
5. When the screws are in place, tighten both screws. When you tighten the screws completely,
there is a small gap between the side arm and the clamp.