Bard Site-Rite IV, Руководство пользователя

Страница: 11 / 36

­
English
3.2 Attaching the Site~Rite
*
IV Scanner to the Roll Stand
To attach the Site~Rite IV Scanner to the roll stand,
1. Rotate the roll stand so that the locking pin on the mounting plate faces you.
2. Hold the Site~Rite IV Scanner with the front facing you.
3. Position the scanner so that the mounting plate on the underside slides into the grooves on
the roll stand’s mounting plate.
4. Slide the scanner on to the mounting plate until it touches the locking pin.
5. Pull down on the locking pin, and slide the scanner past the pin. Release the pin when the
edge of the scanner mounting plate passes over the locking pin.
6. Continue to slide the scanner, until the locking pin snaps into the locking hole. A stop screw
on the opposite side of the mounting plate prevents you from sliding the scanner off of the
mounting plate.
7. The Site~Rite IV Scanner is now attached to the roll stand.
If the scanner is temporarily removed from the roll stand, use the scanner by placing it on a horizontal,
flat surface. The Site~Rite IV Scanner has four black feet to protect both the bottom of the scanner and
the surface on which you place it.
The scanner has a retractable top handle for carrying the scanner when it is temporarily removed from
the roll stand.
3.3 Adjusting the Roll Stand Height and Tilt
To adjust the height, unlock the locking mechanism on the roll stand post by turning the locking knob
counterclockwise, slide the post up or down, and then lock the mechanism by turning the locking knob
clockwise.
To adjust the tilt, turn the adjustment knob located underneath the Site~Rite IV Scanner, until the
desired tilt is achieved.
Site~Rite* IV Ultrasound System Operator’s Manual
Chapter 3: Setting up the Site~Rite* IV System
ACCESS SYSTEMS
1
2
3
Identifier
Locking Pin 1
Label
Mounting Plate 2
Stop Screw 3