Barco LED-PRO, Руководство пользователя

Страница: 30 / 186

16 LED-PRO • User’s Guide
2. Hardware Orientation
LED-PRO Rear Panel
3) Universal Input 3
Five BNC connectors are provided for Universal Input 3 — each with a buffered
loop-through. The input corresponds to Button 3 in the Inputs Section , and
accepts RGB, YUV, S-Video (Y/C), or composite (NTSC, PAL or SECAM) signals.
~
In Appendix A, refer to the “ Input Specifications ” section on page 118
for input video details.
4) SDI Input
One BNC connector is provided for the SDI Input . The input corresponds to the
SD/HD SDI button in the Inputs Section , and accepts SD-SDI or HD-SDI signals.
~
In Appendix A, refer to the “ Input Specifications ” section on page 118
for input video details.
5) LED Interface
One DVI-I connector is provided for the system’s output to an LED wall. The
output is digital only.
~
In Appendix A, refer to the “ Output Specifications ” section on page 119
for output video details.
~
In Appendix A, refer to the “ DVI-I Connector Pinouts ” section on
page 122 for pinout specifications.
6) Ethernet Port
One RJ-45 connector is provided for 10/100BaseT Ethernet communications with
LED-PRO.
~
The port is typically used for diagnostics, or command-line operations via
Telnet.
~
Telnet is via port 10001.
S
telnet 192.168.1.100 10001
In Appendix A, refer to the “ Ethernet Connector ” section on page 123 for
pinouts.
7) RS-232 Port
One 9-pin D connector is provided for RS-232 serial communications with LED-
PRO. The port is typically used for communications with Barco’s
Director
Toolset Graphical User Interface (GUI).
In Appendix A, refer to the “ Serial and Diagnostic Connector ” section on
page 124 for pinouts.
8) Diagnostics Port
One 9-pin D connector is provided for RS-232 serial communications with LED-
PRO. Similar to the Ethernet port, this port is typically used for diagnostics,
uploading code or command-line operations via
HyperTerminal or the Flash
Loader .
In Chapter 4, refer to the “ Diagnostic RS232 ” section on page 88 for port setup
operations. In Appendix A, refer to the “ Serial and Diagnostic Connector ”
section on page 124 for pinouts.
9) AC Connector
One AC Connector is provided for connecting LED-PRO to your facility’s AC
power source. The integral switch turns the chassis on and off.