Barco LED-PRO, Руководство пользователя

Страница: 103 / 186

LED-PRO • User’s Guide 89
4. Operation
Using the Expert Mode Menu
Following are descriptions of all menu functions:
•
Baud — selects the baud rate. Values are: 1200, 2400, 9600, 19200, 38400.
•
Parameters — select from the following values: N81, E71, O71, E72, O72.
•
Handshaking — select from the following values: Off or On (CTS/RTS).
•
Reset — enables you to restore the RS-232 settings to defaults: 38400, N81,
Handshake On.
Please note the following important points regarding diagnostic communications:
•
After connecting your PC’s COM port to LED-PRO’s Diagnostic Port , you may
open a serial terminal session (using HyperTerminal, Procomm, etc.), and
configure the PC to match LED-PRO’s serial port settings as configured in the
Diagnostic RS-232 Menu .
•
At this point, the LED-PRO command prompt ( # ) will be displayed at the terminal.
•
Type " Help " to see a list of remote commands supported. In Appendix B, refer to
the “ LED-PRO Remote Commands ” section on page 128 for a complete list of
commands and descriptions.
bíÜÉêåÉí
On the System Menu , select the Ethernet function to display the Ethernet Menu , which
enables you to set Ethernet parameters.
Figure 4-72. Ethernet Menu (sample)
Following are descriptions of all menu functions:
•
Mode — enables or disables Ethernet communications by turning the LED-PRO’s
Ethernet port on or off.
•
DHCP — turns DHCP on or off.
~
When on , LED-PRO queries the DHCP server for a valid IP address. If
the LED-PRO finds a DHCP server and receives an IP address, the IP
address is shown. If a server is not found, the unit does not get an IP
address allotted to it.
~
When off , you can manually enter a static IP address (with valid subnet
mask and gateway) for Ethernet communication to properly function.
Consult with your network administrator for a valid IP address, subnet
mask and gateway.
E T H E R N E T
> M o d e
O f f
D H C P O f f
S e t S t a t i c I P > >
I P 1 9 2 . 1 6 8 . 0 0 0 . 2 0 0
M 0 0 : 2 0 : 4 A : 8 4 : 9 A : E E
Note It takes several seconds for the unit to query the Ethernet port
and obtain the IP address. During this time the
SEL button
will remain lit.