![background image](http://html1.mh-extra.com/html/barco/actas-2/actas-2_owners-manual_473881036.webp)
ACTAS software
2-23
5975636 ACTAS 2 170297
START ADJUST MENU
Depending on the used adjustment mode, the ACTAS
will act differently.
The menus displayed after the
<ENTER>
key is pressed
in the 'Start adjustment' command menu will prompt the
user (in manual mode) or display messages (auto mode)
to inform users of the process being used.
The menus given as examples are explained under the
section 'The adjustment mode'. Please refer to the
pages from 2-11 to 2-12.
The given example is in case of adjusting one single
stand-alone projector. Please refer to Chapter 4 for
multiple projectors.
Adjust (mode manual
setup 2, proj 808s
ref kind 4 C Temp)
ENT: Start / EXIT
Switching to 20% ;
stabilizing...
---------------- 0----#----------- R
----------#-----0----------------- G
-----------------#------------------B
Gain / ENT: Cut off / EX
Adjust (mode auto
setup 2, proj 808s
ref kind 4 C Temp)
ENT: Start / EXIT
Putting proj
2
operational ...
Initializing
proj
2...
ENTER : start adjust
çè
: other command
Press 'ENTER'
manual mode
Press 'ENTER' e.g.
auto mode
Color adjusted
in 1 iterations
ENT: again
/ EXIT
Color adjusted
in 4 iterations
ENT: again
/ EXIT
Press 'ENTER'
e.g.
manual adjust
SEND AGAIN COMMAND MENU
This function is useful when for some reason the ACTAS
adjustments cannot be carried out in the projector's
settings block that should be used for the application.
After the ACTAS completes the adjustments and the
projector is reconnected to its normal picture source, by
using the function 'Send again', the gain and cut-off
values obtained will be copied into the projector's memory
block that belongs to that normal picture source.
Please note that this method does not take into account
the tolerances of the target picture source.
ENTER : send again
çè
: other command
Send last obtained
gains and cut offs
to current block.
ENT: send
/ EXIT: quit
Settings sent
ENTER: again / EXIT: quit
Press 'ENTER'
Press 'ENTER'
SHOW UNADJUSTED PROJECTORS
COMMAND MENU
The command menu offers access to check how many
projectors are chained in a graphical wall and how many
have not yet been adjusted.
Once the
<ENTER>
key is pressed in the menu, the
number of projectors in the current active configuration
and the number of projectors that have not yet been
adjusted will be displayed.
The addresses of unadjusted projectors can be viewed
by using the '
ç
' and '
è
' arrow keys.
Press 'ENTER'
Press 'ENTER'
Number of unadjusted
projectors:
2 of 6
ENT: show addr
/ EXIT
Unadjusted projector
address: 1
çè
: show other
/ EXIT
ENTER : show
unadjusted
projectors
çè
: other command