![background image](http://html1.mh-extra.com/html/barco/actas-2/actas-2_owners-manual_473881014.webp)
ACTAS software
2-1
5975636 ACTAS 2 170297
2
OVERVIEW FLOWCHART OF THE ACTAS
MENU
The ACTAS software provides menus and display mes-
sages to guide you through the alignment process.
All those menus and messages will be shown on the
LCD display on the Control Unit.
Start-up messages
After the ACTAS is powered, the start-up messages will
be displayed : it gives the information about the EPROM
versions of the ACTAS Control Unit and the Interface,
the type of the sensor and whether it is connected or not.
Next, another message will be displayed, indicating
some settings.
Finally, the command menu 'Start adjust' will be dis-
played and it will remain until operations take place.
Command menus
There are 8 command menus available. Starting from
the 'Start adjust' menu, press the '
è
' key continuously,
the following command menus will be displayed :
u
Send again
u
Show unadjusted projectors
u
Remote control
u
Set parameters
u
Select /learn config
u
Get reference
u
Select /edit setup
Use the '
ç
ç
' key or '
è
è
' key on the Control Unit to
select a desired menu.
Press the <ENTER> key to enter the selected path or
execute the selected command.
start-up
messages
THE ACTAS SOFTWARE
Press the '
è
' key
Press the '
è
' key
Press the '
è
' key
Press the '
è
' key
Press the '
è
' key
Press the '
è
' key
Press the '
è
' key
Press the
'
è
' key
ACTAS
(c) 1995, 1996 BARCO
BARCO ACTAS
CONTROL UNIT V 1.00
Checking hardware ...
SETUP 2
CONFIG 6
MODE
auto
PROJ
auto
ADJPICT
actas interf
BARCO ACTAS
CONTROL UNIT V 1.00
INTERFACE UNIT V1.00
PROBE TYPE NR. 1
ENTER : start adjust
çè
: other command
ENTER : send again
çè
: other command
ENTER : show
unadjusted
projectors
çè
: other command
ENTER : remote control
çè
: other command
ENTER : select / edit
setup
çè
: other command
ENTER : get reference
çè
: other command
ENTER : select / learn
config
çè
: other command
ENTER : set parameters
çè
: other command