ACTAS software
2-8
5975636 ACTAS 2 170297
GET REFERENCE MENU
This function is used in aligning multiple projectors
forming a projection wall. It requests parameters' set-
tings from the reference projector. The reference values
are then used to align other projectors. The projector
that is used as the reference will be remembered by the
ACTAS Control Unit as an adjusted projector in the
configuration.
In the 'Get reference' command menu, press the
<EN-
TER>
key to enter the path, then press the
<ADJUST>
key to start up the process :
1. The brightness and contrast values are read from the
projector and stored into the displayed setup memory
block (e.g. nr 6).
2. The light output reference values for high and low
level test pictures are measured and stored into the
same setup block.
3. An end message will be displayed to report the
termination of the process.
4. Press the
<ADJUST>
key to repeat.
Press the
<EXIT>
key to return.
In the color alignment of a single stand-alone projector,
this step need not be done.
Press the 'ENTER' key
Get reference
into setup nr 6
(Ref kind G2 )
ADJ : start
/ EXIT
Bri,
contr,
48%,
60%,
Press the 'ADJUST' key
e.g.
Low reference : RGB
123, 456, 789
References stored
ADJ: again
/ EXIT
SELECT / EDIT SETUP MENU
This function allows you to select a Setup block and edit
settings of the Setup.
Selecting a Setup memory block
After the
<ENTER>
key is pressed in the 'Select/edit
setup' menu, the 'Select setup' menu will be displayed.
It gives the number of the current block (e.g. Setup 2),
the selected projector type (e.g. 808s) and the phosphor
type (e.g. auto).
Follow the steps below to select a Setup block :
u
Use the '
é
' key and '
ê
' key to access the higher or
lower number Setup block;
u
Press the
<ENTER>
key to save the change: a
message will be displayed to report the saving pro-
cess;
Or press the
<EXIT>
key to return without changes:
a message will be displayed to report the reverting
process.
ENTER : get reference
çè
: other command
Select setup
3 : ( auto
auto )
/
éê
: change
ENT: select
/
EXIT: quit
Press the '
é
' key
Select setup
2 : ( 808s auto )
ADJ : edit
/
éê
: change
ENT : select
/
EXIT: quit
Select setup
3 : ( auto
auto )
ADJ : edit
/
éê
: change
ENT : select
/
EXIT: quit
Press the 'ENTER' key
ENTER : select / edit
setup
çè
: other command
Press the 'ENTER' key
