B&R Industries Automation PC 620, Руководство пользователя

Страница: 322 / 512

322
Software • Automation PC 620 with BIOS
Automation PC 620 User's Manual V 1.90
1.5.3 Upgrade BIOS for 815E
• Download and unzip the zip file from the B&R homepage.
• Copy the files to an MS-DOS startup disk (information about creating a bootable disk can
be found in Section 1.5.7 "Creating a DOS boot diskette in Windows XP" on page 329).
• Place the diskette in the USB floppy drive and reboot the APC620.
• The following boot menu will be shown after startup
1. Upgrade PHOENIX BIOS for 815E
2. Exit
Concerning point 1:
BIOS is automatically upgraded (default after 5 seconds).
Concerning point 2:
Return to the shell (MS-DOS).
• The system must be rebooted after a successful upgrade.
When using a system unit with 2 PCI slots, the DIP switches on the system unit must be set to
profile position 2. When using a system unit with 1 PCI slot, the DIP switches do not have to be
changed.
Information:
When the system has rebooted, setup default values must be reloaded after the
message, "
System CMOS checksum bad
" (press F1 or select "load setup defaults"
in the BIOS setup "exit" menu). Afterwards, the time and date must be set again.
Information:
The exact position and information about DIP switch settings can be
found in Section "Position of the DIP switch for APC620 system units"
on page 331.
Figure 158: DIP switch on system unit (example)
Number Optimized for device
DIP switch setting
1 2 3 4 5 6 7
1)
8
1)
Profile 0 Automation PC 620 system units 5PC600.SX01-
00. Off Off Off Off Off Off - -
Profile 1 Reserved On Off Off Off Off Off - -
Profile 2 Automation PC 620 system units 5PC600.SX02-
00, 5PC600.SX02-01, 5PC600.SX05-00 and
5PC600.SX05-01. Off On Off Off Off Off - -
Table 236: Profile overview