Operation
H25-IR PRO Instruction Manual
44
P/N: 3015-5678 Rev 6
Table 5-5. Logging Data
Step
Button
Description
Sample Screen(s)
1
Ensure that the H25-IR PRO is in
Measure Mode. Use the MODE
button if needed.
2
Press the LOG button to capture
the current (non-zero) leak rate.
You are prompted to press the
ENT button to confirm that you
want to store this value in the
measurement log.
Do nothing (i.e., wait for the
inactivity timeout to occur) or
press the ESC button to return to
the main Measure screen.
3
To log the leak rate value, press
the ENT button when
confirmation is requested. An
acknowledgement screen is
displayed for approximately
5 seconds, followed by the main
Measure screen.
NOTE:
With the exception of the LOG button (discussed in the next section), most of the front panel buttons on
the H25-IR PRO behave similarly in the Measure Mode screen as they do in the SEARCH MODE screen. For
additional information on the ENT (ZERO), Information (
i
), VOL, SETUP, RANGE, and MODE buttons, refer to
the corresponding subsections in the Search Mode Screen section starting on page 36.
GAS TYPE = R134A
ALARM
>=
10.0
RANGE = 0-20 G/YR
MEASURE {---------}
MEASUREMENT LOG
LOG 1.2 G/YR
AS 1 OF 50
PRESS ENTER TO CONFIRM
MEASUREMENT LOG
MEASUREMENT #1
LOGGED
TOTAL = 1.2 G/YR
Содержание H25-IR PRO
