The External HA settings screen on an LS9-32
The LS9 External HA screen includes the following setting:
1. COMM Port Setting
— Set this to the same MY expansion
slot where the 6416Y2 card being used for console remote
control is installed. Setting this field to the Off setting (‑‑‑‑)
will stop all remote control communication. Use the
D
ec
/I
Nc
keys to select a port, and then press the
e
NteR
key.
2.
Remote Preamps ID
— Available remote controllable pre‑
amps are shown in groups of eight channels; note that the
device name is always displayed as “AD8HR.” The red “+48V
Master” text indicates that the remote AD8HR preamp’s
master on/off switch for phantom power is on. The 6416m
does not have a separate phantom power master on/off
switch, so this parameter will always be on.
3.
Expansion Slot Port Assignment
— Use this field to assign
channels of the 6416Y2 card(s) installed in the MY expan‑
sion slots to the groups of eight remote mic preamp
channels. Each 6416Y2 offers two groups of eight channels,
1‑8 and 9‑16, at the 44.1/48kHz sample rate.
4.
Virtual Mic Preamps
— This overview shows the current
level setting for each remote mic preamp device
connected.
Selecting one of the virtual mic preamp fields and then hitting the
e
NteR
button on the LS9 will bring up the full size External HA screen that allows
all remote controllable parameters to be viewed and edited, displayed
in groups of eight channels. The available virtual racks can be selected by
choosing one of the numbers at the top of the screen—two virtual racks for
the LS9‑16 and four virtual racks for the LS9‑32. (See below.)
67
m
-
Control
