Avery Weigh-Tronix ZM401, Руководство по обслуживанию

Страница: 68 / 156

68 ZM400 Series Indicators Service Manual
6 ADMIN level menus
SubnEt The Subnet Mask address is used to divide a network into
smaller subnets. The address is a numeric entry in four parts
or octets (###. ###. ###. ###).
Key in each octet and press
ZERO
to accept it.
gAtEWAy The Gateway address allows one network a gateway to
another network. The address is a numeric entry in four parts
or octets (###. ###. ###. ###).
Key in each octet and press ZERO to accept it.
dhcP Use this to enable or disable DHCP capability. This allows a
DHCP server to automatically set the indicator IP, subnet and
gateway addresses. Choices are
on (enabled) or oFF
(disabled). Default is oFF .
con.no This stands for connection number. This lets you set the Port ,
tyPE and hoSt for each of 5 ( E-nEt 1 through E-nEt 5 )
Ethernet ports. This allows multiple (up to five) devices to
access or control information to/from the indicator. (Referred
to as
E-nEt 1 through E-nEt 5 in Protocol menu).
E-nEt 1-5 Choose the Ethernet port to set up.
Port x Key any port number from 1 to 65535.
Typically the subnet mask address is set to 255,255,255,0 which means the first three
octets in the device network are the same and only the fourth octet of the IP address
is unique for each device.
In most simple networks a gateway address is not used and is set to 0,0,0,0. If the
indicator is part of a network that uses an access point to another network, then a
gateway address may be required. (Consult the site IT specialist)
If DHCP is enabled on , the above settings for the IP, Subnet and Gateway are set by
the network server. In applications where the indicator Ethernet port is connected
directly to a PC, laptop, printer or other non-DHCP device, you must set DHCP to
OFF .
Some port numbers are reserved. Contact your IT department for the correct port
number to use.