Avery Weigh-Tronix ZM401, Руководство по обслуживанию

Страница: 81 / 156

ZM400 Series Indicators Service Manual 81
7.1 SMA Protocol
7.1.5 Scale Information Command Response
The ‘I’ and ‘N’ commands are used together to get all of the scale information data. The
‘I’ command will always return the 1st response below. The ‘N’ command must be sent
multiple times to get the 2nd, 3rd, 4th, 5th, and 6th responses. Once the 6th response
is received, the next ‘N’ command will return an Unrecognized Command Response.
At this point you would have to send another ‘I’ command to get the 1st response again.
<LF><xxx>:<yyyyy><CR>
1st response: <xxx> = “SMA”
<yyyyy> = compliance level/revision
2nd response: <xxx> = “TYP”
<yyy> = ‘S’
3rd response: <xxx> = “CAP”
<yyyyy> = uuu:ccc:n:d where
uuu = unit of measure
ccc = capacity of the range lower range (capacity of the scale
is multi-interval is disabled)
n = least significant count-by digit for this range
d = decimal point position for this range
‘0’ = none
‘1’ = xxxx.x
‘2’ = xxx.xx
etc.
4th response: <xxx> = “CAP”
<yyyyy> = uuu:ccc:n:d where
uuu = unit of measure
ccc = capacity of the range upper range (4th response will not
be sent if multi-interval is disabled)
n = least significant count-by digit for this range
d = decimal point position for this range
‘0’ = none
‘1’ = xxxx.x
‘2’ = xxx.xx
etc.
5th response: <xxx> = “CMD”
<yyyyy> = “PTMCU” list of supported SMA commands.
Level 1 commands are not included in the list.
6th response: <xxx> = “END”
<yyyyy> = nothing
7th & more -
responses:
Subsequent N commands will return a ‘?’ response. Unrecognized
Command Response