Autonics AiC-D-20LA, Руководство пользователя

Страница: 38 / 116

4 Installation of Motor
38 © Copyright Reserved Autonics Co., Ltd.
4.3 Connection with Load
When connecting the load, be sure of alignment of the center, tension of the belt, and
parallel of the pulley. When connecting the load such as a pulley or a belt, be cautious of the
allowable thrust load, radial load, and shock, as well as tighten the screw for a coupling or a
pulley not to be unscrewed.
When attach a coupling or a pulley to the shaft, be cautious of damage on shaft or bearings
and it is banned to disassemble or change structure of the device or the shaft for connecting
with a load.
4.3.1 Direct Load Connection with Coupling
When connecting a load such as Ball screw or Tm screw directly to the shaft of the motor,
use flexible coupling as image showing above. If the center of the load and the shaft is not
aligned, it may cause severe vibration, damage on shaft or shortened life cycle of bearings.
4.3.2 Load Connection with Pulley, Belt, and Wire
The motor shaft and the load shaft should be parallel. Connect the motor shaft and the line
which connects the center of two pulleys to a right angle.
4.3.3 Load Connection with Gear
The motor shaft and the load shaft should be parallel. Connect the motor shaft to the center
fo gear teeth side to be interlocked.