Do-more H2 Series PLC Hardware User Manual, 1st Edition, Rev. F - H2-DM-M
1–25
Chapter 1: Getting Started
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
With the cursor in the position to the right of
contact T1_Start, you are going to begin
drawing a branch circuit. Under the Edit
drop down menu, select Wire, then select
Down. Notice the shortcuts that are available
for wire drawing. The wire that should now
appear in your ladder could have also been
drawn using the shortcut Ctrl+Down Arrow.
NOTE:
There are also Delete Wire options
in the Edit drop down menu that are used
to erase any wires not needed.
Now place the cursor in the space to the left of the new line and select another normally open
contact.
Type in the nickname “T1_Manual”
and assign bit C2. Select OK to accept
and Rung #1 should now resemble the
rung seen on the following page.
Содержание Do-more H2 PLC Series
Страница 2: ...Notes...
Страница 6: ...Notes...
Страница 8: ...Notes...
Страница 231: ...Do more Product Weight Table A A A Appendix Appendix Appendix In This Appendix Do more Product Weight Table A 2...
